Using the ReVolt Series with Wall of Sound
You can pair your ReVolt with our proprietary DynIRs using Wall of Sound for expanded tone shaping potential.
With ReVolt Guitar or ReVolt Bass you are entitled to 10 expertly curated DynIR cabinets by registering the pedal to your Two notes account. Please see this article that provides a simple walkthrough on how to register your ReVolt Guitar or ReVolt Bass.
To use DynIRs with the ReVolt Series, use the “OUT” output to connect ReVolt to the instrument input of your audio interface with an instrument (unbalanced) cable. The OUT sends the “dry” signal of ReVolt Series Pedal to your audio interface. You can then apply a digital cabinet simulation to the ReVolt signal in your DAW using Wall of Sound.
You can also use the DI (XLR) output for a noiseless transmission of the signal between ReVolt and the audio interface. In this setup, set the CAB SIM switch to O in order to send the dry signal of ReVolt to the audio interface.
Top Tip: To hear the cabinet simulation facilitated by Wall of Sound while playing your guitar, please activate direct monitoring of the track in your DAW.
Our support team is here to assist you! For any enquiries, please head over to our Help Desk and submit a ticket to speak directly to one of our in-house specialists.
Registering your ReVolt Guitar or ReVolt Bass and redeeming your DynIRs
With your purchase of either a ReVolt Guitar or ReVolt Bass pedal, you are entitled to 10 DynIR virtual cabinets. To redeem the cabinets, please register your Analog Amp Simulator at the following page in your user account: ...
How to Configure ReVolt Guitar or ReVolt Bass With a C.A.B. M+
Seeking the ultimate fly rig? Combine ReVolt Guitar or ReVolt Bass with the C.A.B. M+ and discover a world of next-generation virtual cabinet emulation fused with sublime analog warmth. Together they offer virtually unlimited tonal possibilities, all ...
Using Pedals with ReVolt's Effects Loop
ReVolt is equipped with an effects loop allowing you to place effect pedals after the preamp and before the outputs of ReVolt. Traditionally, users tend to place time-based FX (delay & reverb pedals) in the effects loop for optimal performance. To do ...
Configuring the ReVolt Series in 4-Cable Mode
Supercharge your existing setup by adding ReVolt Guitar’s or ReVolt Bass’ 3 channels to your amp following our step-by-step guide below: Activate the 4-Cable Method switch (I position) Connect your guitar/pedalboard to ReVolt’s input (GUITAR IN) ...
How do I Register my Le-Series Preamp Pedal and get my 16 DynIR Virtual Cabinets?
In order to register your Le-Series Preamp Pedal and get your 16 DynIR virtual cabinets for the Wall of Sound or GENOME plugins, please follow these steps: Go to the Two notes Store and create an account (or log in if you already have a Two notes ...