Using Pedals with ReVolt's Effects Loop

Using Pedals with ReVolt's Effects Loop

ReVolt is equipped with an effects loop allowing you to place effect pedals after the preamp and before the outputs of ReVolt. Traditionally, users tend to place time-based FX (delay & reverb pedals) in the effects loop for optimal performance. To do so:
  1. Disengage the 4-Cable Method switch ( O position)
  2. Connect your guitar/pedalboard to ReVolt’s input (GUITAR IN)
  3. Connect the effects SEND of ReVolt to the first effect’s input
  4. Connect the output of the last effect to the effects RETURN of ReVolt

With this configuration, you will be able to hear the sound of the pedals in the effects loop through the Headphones-, OUT- and DI-outputs.

Having issues?

Our support team is here to assist you! For any enquiries, please head over to our Help Desk and submit a ticket to speak directly to one of our in-house specialists.





    Limited Service Notice
    Please be advised, we are currently running a limited Help Desk Service from the 06th to the 12th of June 2025.

    Rest assured, your enquiry is of the utmost importance to Two notes Audio Engineering and our support team are committed to resolving your enquiry as a matter of priority upon their return.

    If you have licence issues with our software, close the software then go to this page  https://www.two-notes.com/en/my-two-notes/?section=software

    Click on the RENEW button to renew your licence, and open the software again.






      • Related Articles

      • How to Configure ReVolt Guitar or ReVolt Bass With a C.A.B. M+

        Seeking the ultimate fly rig? Combine ReVolt Guitar or ReVolt Bass with the C.A.B. M+ and discover a world of next-generation virtual cabinet emulation fused with sublime analog warmth. Together they offer virtually unlimited tonal possibilities, all ...
      • Torpedo Reload II - FX Loop Behaviour & Switching Troubleshoot

        Torpedo Reload II’s full-featured FX loop offers a myriad of connectivity options and - if configured incorrectly in relation to the desired outcomes of your rig - can cause unwanted sound output issues. Below are some considerations to check in the ...
      • Configuring the ReVolt Series in 4-Cable Mode

        Supercharge your existing setup by adding ReVolt Guitar’s or ReVolt Bass’ 3 channels to your amp following our step-by-step guide below: Activate the 4-Cable Method switch (I position) Connect your guitar/pedalboard to ReVolt’s input (GUITAR IN) ...
      • Configuring an Amplifier & FX Processor With the 4 Cable Method

        What is the Purpose of the 4 Cable Method? The 4 cable method is a way to connect an FX processor to your amplifier and Torpedo device. It will isolate your amplifier's preamp and power amp sections as independent components. This way, you will have ...
      • How to Configure ReVolt Bass and OPUS

        In the following Help Desk Article, we discuss the optimal means of connecting ReVolt Bass and OPUS for the ultimate Fly-Rig. MIDI Connectivity In terms of MIDI connectivity, simply connect a 3.5mm (1/8-inch) TRS jack to 3.5mm (1/8-inch) TRS jack ...