Torpedo Reload II - The Celestion Approved Load Response

 Response, Tone - they’re the bedrock of any performance, all rooted in a premier load-response that’s second-to-none. It’s this mantra that’s spawned Reload II’s all-new reactive load and the final word in next-generation Load Box technology. For starters, a ground-up rework of our load design delivers an impedance curve inspired by Celestion®’s iconic driver line for an industry-first “Celestion® Approved Load Response”. Fuse this with switchable multi-impedance capability (4-, 8- and 16Ω), and you’re locked to get the best out of every amp in your collection.

In developing Reload II's all-new reactive load featuring a Celestion Approved Load Response, we were conscious not to match to a specific speaker (due to variations rooted in the accompanying enclosure size) but to a range of drivers, averaging the impedance for optimum performance across the breadth of amplifiers on the market. The diagrams below illustrate the impedance curves of Reload II's reactive load when set at 4-, 8- or 16-Ohms operation.

Having issues?
Our support team is here to assist you! For any enquiries, please head over to our Help Desk and submit a ticket to speak directly to one of our in-house specialists.

• Related Articles

• Torpedo Reload II - Load Box Centric FAQs

  Featuring twin-channel operation, selectable multi-impedance compatibility and true continuous attenuation, Reload II is our most advanced Load Box to date. In this article, we summarise some key information relating to what a Load Box is, setup ...

• Torpedo Reload II | Output Power

  Reload II’s continuous attenuation is achieved by pairing the reactive load box with a transparent solid state power amplifier. The built-in power amplifier is able to deliver the following (maximum) power in regards to the impedance of the connected ...

• Torpedo Reload II - Using an External Cabinet Simulator with Reload II

  Looking to add a hardware Cabinet Simulator to your Reload II rig? Read on for our connectivity suggestions relating to this. Placement in Reload II’s Signal Chain In routine use of a tube amplifier, it is highly recommended that the power output of ...

• Torpedo Reload II - Reload II Source Compatibility FAQs

  Whether it’s a Modeller, Fly-Rig, Amplifier or Amp Sim, Reload II is spec’d to deliver on any mandate. In the following help desk article, we outline what devices can be connected to the Input stage of Reload II through a series of ...

• Can I Mismatch The Impedance of an Amp and Loadbox?

  The speaker output of a tube amp is designed to be matched to one (or several) specific load(s). A 8 ohms speaker output is supposed to be connected to a 8 ohms speaker or loadbox. In some situations however, you may not be able to match the ...