Powering Opus With a 3rd Party Pedalboard Power Supply

Powering Opus With a 3rd Party Pedalboard Power Supply

Out-the-box, OPUS includes a grounded power supply that we have deemed necessary for optimum performance. For users seeking to power OPUS with a conventional 3rd-party power supply, the following grounded-power supplies are recommended:

  • Voodoo Lab 2+
  • Voodoo Lab iso5
  • Cioks DC7
  • Cioks SOL
  • Truetone CS7

When connecting OPUS to one of the aforementioned 3rd-party power supplies, please ensure a suitable output tap is used corresponding to the designated power requirements of OPUS:

  • Connector: 2.1mm x 5.5mm
  • Polarity: Center negative
  • Voltage: 12V DC
  • Current: 200mA

Top Tip: Not using a grounded power supply can result in additional noise induction into the OPUS architecture; as such, we always recommend using a grounded power supply.

Having issues?
Our support team is here to assist you! For any enquiries, please head over to our Help Desk and submit a ticket to speak directly to one of our in-house specialists.

    • Related Articles

    • Choosing a Power Supply for Your ReVolt Series Amp Sim

      Aside from the included Power Supply for your ReVolt pedal, there are a myriad of options out there that can be used to power the unit as part of your pedalboard rig. One important consideration to mention: the PSU supplied with your ReVolt Pedal is ...

    • Integrating OPUS into your Pedalboard Rig

      Make OPUS the beating heart of your pedalboard. Its stellar front- and rear-loading capability, in tandem with your pre- and post-amp pedal collection, delivers the ultimate ‘go-anywhere’ fly-rig! First, position OPUS after any drive and distortion ...

    • What Power Supply Do I Need for the Le Preamp Series?

      If you wish to use a power adapter other than the one provided with your Le Preamp pedal, here are the specifications that need to be adhered to: Voltage: 9V or 12V DC. The power supply needs to be Direct Current (DC); you cannot use an Alternating ...

    • Managing Noise Issues and Gain Staging on OPUS

      When gain staging in the OPUS architecture, the signal level at the input is a key factor to consider - especially when mitigating the impact of noise on your audio signal. The VU meters on OPUS’ OLED display indicate both the input and output levels ...

    • What Power Supply Do I Need for the Torpedo C.A.B.?

      If you wish to use a power adapter other than the one provided with the Torpedo C.A.B., here are the specifications that need to be adhered to: Voltage: 12 to 15 V DC. The power supply needs to be Direct Current (DC); you cannot use an Alternating ...


    Limited Service Notice

    Please be advised, we are currently running a limited Help Desk Service from the 20th December 2024 to the 13th January 2025.

    Rest assured, your enquiry is of the utmost importance to Two notes Audio Engineering and our support team are committed to resolving your enquiry as a matter of priority upon their return.