OPUS's AUX Input & Phones Output - Stereo & Mono Signals

OPUS's AUX Input & Phones Output - Stereo & Mono Signals

When using the AUX input and the headphone output, the user case scenarios in regards to mono and stereo signals are outlined below:

  • The AUX IN accepts stereo signals at its input. The signal will be played in stereo via the headphone output. The AUX IN is only routed to the headphone output and not the DI or LINE outputs
  • The internal DSP processing of guitar or bass tones in OPUS is mono and as such is audible only in mono via the headphone output
  • When playing a stereo source via the AUX IN and a DSP processed signal from the OPUS architecture (using a TSM amplifier, a DynIR cabinet, etc. ), the AUX IN will be monitored in stereo and the DSP signal monitored in mono via the headphone output

Having issues?
Our support team is here to assist you! For any enquiries, please head over to our Help Desk and submit a ticket to speak directly to one of our in-house specialists.




    Limited Service Notice
    Please be advised, we are currently running a limited Help Desk Service from 7th May 2024 to the 13th May 2024 (included). Our response time over this period will be slower than usual.
    Rest assured, your enquiry is of the utmost importance to Two notes Audio Engineering and our support team are committed to resolving your enquiry as a matter of priority upon their return to full staff.




      • Related Articles

      • How does GENOME handle mono & stereo signals

        In the following knowledge-base article we highlight how GENOME is configured for Mono and Stereo Signal processing both at the input stage and within the component level processing of the application. GENOME's Input Stage GENOME (V1.03) has been ...

      • Configuring OPUS to Send 2 Different Signals From The LINE & DI Outputs

        Prepare for various performance and recording situations with OPUS' Dual Mono / LINE OUT ROUTING capabilities! Simply define a terminus in OPUS’ DSP signal chain and you’re set to send two distinct signals from the DI (XLR) and LINE (1/4-inch TRS) ...

      • Using GENOME with a Stereo Amp DI

        In the following knowledgebase article we highlight how to configure GENOME - or multiple instances of GENOME - to work alongside a Stereo DI signal, be it a Pedalboard, Physical Amp / Loadbox or Modelling Processor. What is a Stereo DI? A Stereo DI ...

      • How Does the Output Mode Work on Torpedo Live?

        The output parameter can be accessed through the Setup Menu/Output (parameter 6/9) The Torpedo Live is a mono unit, but the S/PDIF digital output carries 2 channels: the Wet (with speaker simulation) or Dry (without speaker simulation) signal, or a ...

      • Integrating OPUS into your Pedalboard Rig

        Make OPUS the beating heart of your pedalboard. Its stellar front- and rear-loading capability, in tandem with your pre- and post-amp pedal collection, delivers the ultimate ‘go-anywhere’ fly-rig! First, position OPUS after any drive and distortion ...